We added preliminary IPv6 support to Condor 7.7.5.  As of 7.7.5, this functionality is experimental and is disabled by default.  You can enable the support if you would like to try it out.

IPv6 support is available in 7.7.4, but has a severe bug where the condor_starter will likely crash when attempting to connect to another computer over IPv6.

{section: Limitations}

Later versions of Condor should remove all of these limitations.

*: ENABLE_IPV6 must be specifed in your global Condor configuration file, not in one of you local configuration files (the ones specified with LOCAL_CONFIG_FILE or LOCAL_CONFIG_DIR). #3277
*: Microsoft Windows is not supported.
*: Mixed IPv4/IPv6 pools are not supported.
*: Security policies cannot use IP addresses, only hostnames.  (If you use NO_DNS=TRUE, the "hostnames" are reformatted IP addresses, and you can match against those.)
*: You must set NETWORK_INTERFACE to a specific IPv6 address.  It is not possible to use multiple IPv6 interfaces on a single computer.
*: Many of these settings require a condor_restart; just a condor_reconfig is likely to be insufficient.

Possibly limitations:

*:You must have valid IPv6 (AAAA) DNS and reverse DNS records for the computers.  (NO_DNS=TRUE removes this limitation.)


{section: Enabling IPv6}

1: Set =ENABLE_IPV6 = TRUE=
{code}
ENABLE_IPV6 = TRUE
{endcode}

2: Specify the IPv6 interface to use.  Note, do _not_ put [square brackets] around this address.
{code}
NETWORK_INTERFACE = 2607:f388:1086:0:21b:24ff:fedf:b520
{endcode}

3: Do a condor_restart.

{section: Additional Notes}

If you specify =CONDOR_HOST= or =COLLECTOR_HOST= as an IP address, you must put the address, but not the port, in square brackets.  You can continue to specify hostnames.  For example:
{code}
CONDOR_HOST =[2607:f388:1086:0:21e:68ff:fe0f:6462]
# This configures the collector to listen on the non-standard port 5332.
COLLECTOR_HOST =[2607:f388:1086:0:21e:68ff:fe0f:6462]:5332
{endcode}
Because IPv6 addresses are not supported in the security settings, you will be unable to use =$(CONDOR_HOST)= or =$(COLLECTOR_HOST)= in your security configuration if you specify an IP address.

When using NO_DNS, IPv6 addresses are turned into hostnames by taking the IPv6 address, changing colons to dashes, and appending DEFAULT_DOMAIN_NAME.  So 2607:f388:1086:0:21b:24ff:fedf:b520 becomes 2607-f388-1086-0-21b-24ff-fedf-b520.example.com (assuming DEFAULT_DOMAIN_NAME=example.com)